Categories

How To Clean Cut Panel Trunking & Din Rail Everytime!

Panel builders use large quantities of both DIN rail for mounting components in control panels and plastic conduit trunking for keeping wiring neat and organised. Both components are typically supplied in 3m lengths so the need to cut them is an essential part of each day.

 The faster this operation can be made and the neater the result, the more productive the builder becomes....

 

Greenlee Din Rail Cutter

The new DIN rail cutter creates accurate cuts thanks to the built-in measuring device to enable set lengths to be set up and then cut equally. The finished end retains the profile shape without distortion, and without any burr - so eliminates time currently spent deburring with files or reshaping.

The long handle creates high leverage cuts with minimal input from the operator through its 5 popular DIN rail profiles. If unslotted rails are used, the tool features a neat mounting slot punch to add these where required for fixing points.

 

 

Greenlee Panel Trunking/Cable Duct Cutter

Cutting of plastic cable trunking can be achieved with a very similar tool. The maintenance-free cutting mechanism is housed in high-quality stainless steel that can cut through even tough halogen free trunking up to 125 x 2.5mm with ease. Clean burr free results every time with the almost wear free blade design. The blade is safely guarded by a protective spring loaded shield to prevent damage or injury.

In addition, the operation lever mechanism is equipped with a reset spring. This means that the hand lever automatically returns to the initial position after the cutting operation, ensuring that the blade is always under the protective cover and eliminating any chance of injury. An integrated measuring device allows for accurate lengths to be cut.

 

Interested in either of the above tools?

Click the button below and one of our sales team will be in touch...

 

 REQUEST A CALL BACK